10A 220V relay output controls Sauna Thermostat Controller With NTC sensor
LCD blue tape crystal display
Power down setting memory function
Temperature measuring range: 0~100°C
Temperature controlling range: 18~65°C（Custom adjustment range 18-110°C, please leave a message.）
Power: 220VAC±10%, 50HZ
Input: 1 NTC sensor
Output: one 10A relay output controls heating
Consumption :≤3 w
Cut-out size: approx. 104×64(mm); Screen size: 70×29(mm); Panel: 122×74.5×4.6(mm)
Ambient requirements: temperature: -10~60°C; humidity: 20~85% (No condensate)
Buttons Operation Description
Power: On/Off by single click
SET: Single click, enter into setting mode, the temperature value flash and can be adjusted by clicking . Single Click SET button again, time value flash and can be adjusted by clicking . Single click SET button to confirm and exit.
The Fault Code Table
1 x temperature controller
1 x User manual
Khan steam room, Light valley house, the infrared sauna room, steam sauna room.
Controller connection load calculation method (three types):
1. Inductive load: The controller connects the compressor, heat pump and other loads.
Calculation formula: working voltage (U) x maximum relay capacity (I)/8;
For example: The controller connects the compressor voltage is 220V, the maximum capacity of the relay is 30A, the controller connection maximum power cannot exceed 220Vx30A/8=825W.
2. Resistive load: The controller connects heating rods, heating pads, electric water heaters and other loads.
Calculation formula: working voltage (U) x maximum capacity of the relay (I)/2;
For example: The controller connection heating rod voltage is 220V, the maximum capacity of the relay is 10A, the maximum power of the controller connection cannot exceed 220Vx10A/2=1100W.
3. Special load: The controller is connected to incandescent lamps;
Calculation formula: Operating voltage of load (U) x Maximum capacity of relay (I)/15